after setting up my breadboard as a PICDEM Z board i altered the UART to invert the bits since im not using a driver such as the Max232 i am using 2 resistors instead so invert is needed… I got a 4mhz crystal i pulled from another pcb and so far so good heh… here is my hyperterminal window:
Ill edit the code more and setup a second device and see what i can do heh… later
UPDATE:
Hey guys i just noticed this would be so messy if i try to do this on breadboard heh. Since the hardware is mostly fixed i will be make some demo boards based on the PICDEM Z board from Microchip. They will be small and mainly for this RF project. But ill be sure to breakout as much as i can.
So this project will be on HOLD until boards are done.