Take a look at these 2 boards. I will make the top layer with a special label paper. The top layer will just be PIN NAMES… (Ill take pics when done)
One is a break out for a MicroSD card with Pull Up resistors on each line to save power and also a 0.1uf cap to clean the power supply a bit. Also has a Detection pin which is pulled up. So when a card is inserted that pin is tied to GND.
The Olimex Expansion board is just a board that lets me get to all the pins top side and in a neat fashion. Also i can power my device via USB micro. I will use this to simply place jumpers from board to a breadboard or something.
UPDATE: Added new images of the top layer with PIN Names to above gallery…